Instructions

Versiplug Instructions

1. With your PWC on a trailer or stand, unscrew and remove your factory drain plugs

2. Screw the Versiplug into the factory flange with the supplied o-ring as shown below.

That’s it! Check on yor PWC from time to time when you’re riding to make sure the Versiplug and the factory bilge are doing ther job.

Important Note:

Put the original plugs in a compartment of the PWC where you can get them if you keep them. If you’re going to leave your PWC in the water with out riding it for more than an hour so, you should put the factory plugs back in! The versiplug will only drain your hull when the boat is moving or when the boat is beached above the waterline.